Dataset Listing

Luquillo Mountains - Geophysics, Ground Penetrating Radar (GPR) (2012-2015)

Geophysical surveys

Variables:  ground penetrating radar, terrain conductivity, electrical resistivity imaging

Standard Variables:  Resistivity, electrical

Date Range:  (2012-05-30 to 2015-11-01)

Dataset Creators/Authors:  Comas, Xavier; Hynek, Scott; Wright, William; Brantley, Susan L.

Contact:  Xavier Comas, Miguel Leon, leonmi@sas.upenn,edu

Field Area:   Northeastern Puerto Rico and the Luquillo Mountains

Keywords & XML
  • Description

    Geophysical surveys conducted during the summer of 2014 followed on previous work that investigated the nature and spatial variability of ground penetrating radar (GPR) reflections in the Rio Icacos watershed (Figure 1a). GPR surveys using a variety of shielded (160 MHz) and unshielded (50, 100 and 200 MHz) antennas (Figure 1e) was combined with multi-frequency terrain conductivity measurements to upscale previous measurements.
    Figure 1a shows a 2 km long transect (red line) across a trail in the Rio Icacos watershed. The transect in the northern edge had an approximately elevation of 640 m, and ended in the southern edge below 540 m elevation and close to the knickpoint. The GPR data along the transect revealed a series of vertical zones with presence of chaotic reflectors (Figure 1b, between 240-265m, 270-300 m, and 320-350 m along the transect; and Figure 1c, between 690-750 m along the transect). These areas repeated at several locations along the 2 km transect (white lines in Figure 1a). Other GPR reflector facies signatures (not shown here) included two landslide locations (yellow lines in Figure 1a); and an area of laterally continuous reflectors (blue line in Figure 1a) towards the end of the transect and close to the knickpoint.
    Terrain conductivity surveys consistently depict a) increases in terrain conductivity; and b) decreases in magnetic susceptibility that coincide with the vertical zones of chaotic GPR reflectors described above (shaded areas in Figures 1b and 1c)
    We attribute these areas of enhanced GPR reflections to vertical fracturing within the bedrock-regolith interface associated with the formation of corestones. Water infiltration may cause regolith wash off (resulting in a decrease in electrical conductivity) and concentration of corestones (resulting in increases in magnetic susceptibility). This preliminary hypothesis is confirmed by the presence of large corestones adjacent to the transect (Figure 1d) and following topographic valley areas (Figure 1a).
    These results confirm the potential of hydrogeophysical measurements for understanding variability of bedrock-regolith interface in the Icacos watershed at large (i.e. km) scales and have direct implications for the controls on subsurface fluid circulation and presence of preferential groundwater flow.

    GPR data found here in the second link are raw data, data was processed and interpreted in Orlando et al. 2016 ((DOI: 10.1002/esp.3948):

    “GPR data processing was performed using ReflexW by Sandmeier Scientific. Steps were limited to: (a) a ‘dewow’ filter over a 10 ns time-window; (b), application of a time-varying gain; (c) a bandpass filter; (d) a static correction; and in some cases, (e) Kirchhoff migration based on a single EM wave velocity as determined from the CMP profiles.”
  • Keywords

    GPR, ground penetrating radar, terrain conductivity, electrical resistivity imaging

    XML Metadata

    XML is in ISO-19115 geographic metadata format, compatible with ESRI Geoportal Server.

  • Citation for This Dataset

    Comas X., Hynek S., Wright W., and Brantley S.L. 2014. Geophysical Surveys of Luquillo. Florida Atlantic University.

    Citation for This Webpage

    Comas, Xavier; Hynek, Scott; Wright, William; Brantley, Susan L. (2015). "CZO Dataset: Luquillo Mountains - Geophysics, Ground Penetrating Radar (GPR) (2012-2015)." Retrieved 22 Feb 2020, from


Luquillo Mountains - Poster From AGU 2014 Describing Geophysical Surveys

(.pdf)   Data Level 2

GPR Data - Raw GPR, GEM data, and field notes

(f05/)   Data Level 0

Data Use Policy
Data Sharing Policy
  • Data Use Policy

    DRAFT v.0.4.0

    1. Use our data freely. All CZO Data Products* except those labelled Private** are released to the public and may be freely copied, distributed, edited, remixed, and built upon under the condition that you give acknowledgement as described below. Non-CZO data products — like those produced by USGS or NOAA — have their own use policies, which should be followed.

    2. Give proper citation and acknowledgement. Publications, models and data products that make use of these datasets must include proper citation and acknowledgement. Most importantly, provide a citation in a similar way as a journal article (i.e. author, title, year of publication, name of CZO “publisher”, edition or version, and URL or DOI access information. See Also include at least a brief acknowledgement such as: “Data were provided by the NSF-supported Southern Sierra Critical Zone Observatory” (replace with the appropriate observatory name).

    3. Let us know how you will use the data. The dataset creators would appreciate hearing of any plans to use the dataset. Consider consultation or collaboration with dataset creators.

    *CZO Data Products.  Defined as a data collected with any monetary or logistical support from a CZO.

    **Private. Most private data will be released to the public within 1-2 years, with some exceptionally challenging datasets up to 4 years. To inquire about potential earlier use, please contact us.

  • Data Sharing Policy

    DRAFT v.0.2.5

    All CZO investigators and collaborators who receive material or logistical support from a CZO agree to:

    1. Share data privately within 1 year. CZO investigators and collaborators agree to provide CZO Data Products* — including data files and metadata for raw, quality controlled and/or derived data — to CZO data managers within one year of collection of samples, in situ or experimental data. By default, data values will be held in a Private CZO Repository**, but metadata will be made public and will provide full attribution to the Dataset Creators†.

    2. Release data to public within 2 years. CZO Dataset Creators will be encouraged after one year to release data for public access. Dataset Creators may chose to publish or release data sooner.

    3. Request, in writing, data privacy up to 4 years. CZO PIs will review short written applications to extend data privacy beyond 2 years and up to 4 years from time of collection. Extensions beyond 3 years should not be the norm, and will be granted only for compelling cases.

    4. Consult with creators of private CZO datasets prior to use. In order to enable the collaborative vision of the CZO program, data in private CZO repositories will be available to other investigators and collaborators within that CZO. Releasing or publishing any derivative of such private data without explicit consent from the dataset creators will be considered a serious scientific ethics violation.

    * CZO Data Products. Defined as data collected with any monetary or logistical support from a CZO. Logistical support includes the use of any CZO sensors, sampling infrastructure, equipment, vehicles, or labor from a supported investigator, student or staff person. CZO Data Products can acknowledge multiple additional sources of support.

    ** Private CZO Repository. Defined as a password-protected directory on each CZO’s data server. Files will be accessible by all investigators and collaborators within the given CZO and logins will be maintained by that local CZO’s data managers. Although data values will not be accessible by the public or ingested into any central data system (i.e. CUAHSI HIS), metadata will be fully discoverable by the public. This provides the dual benefit of giving attribution and credit to dataset creators and the CZO in general, while maintaining protection of intellectual property while publications are pending.

    † Dataset Creators. Defined as the people who are responsible for designing, collecting, analyzing and providing quality assurance for a dataset. The creators of a dataset are analogous to the authors of a publication, and datasets should be cited in an analogous manner following the emerging international guidelines described at

Explore Further

data |

Explore Further